Homepage – http://www.kleenkuip.com
Used Carpet Cleaning Equipment – http://www.kleenkuip.com/used_equipment/used_equipment.htm
Carpet Cleaning Discussion Forum – http://www.kleenkuip.com/forum
Carpet Cleaning Blog – http://kleenkuip.wordpress.com/
Like Us on Facebook – http://www.facebook.com/KleenKuip
Follow Us on Twitter – http://twitter.com/kleenkuip
Our Mission here at Octi-Dry® Industries Inc. is to create more Profit, Time, Confidence in the use of our products. Our Experience and Knowledge comes to us just as yours does from using and testing our products on “Real Disaster Situations”. Our products are not created in some marketing room! They are born into real job situations, where we have worked through the hard part.
Our “Octi-Dry ® Wall Drying System” and our “Octi-Mat ® Floor Drying System” are a vital component in the (3) three ingredient recipe for Drying Wet Damage Structure! That recipe is:
1) Warm/Hot Dry Air,
2) Warm/Hot Dry Air at High Speed,
3) A way to “Direct” Warm/Hot Dry air specifically where you want it!
Octi-Dry® Industries Inc.®
“WE DRY HARDER”
Octi-Dry® Wall Drying System Can be used individually or attached end to end for continuious applications! All wet walls need not be removed!! “Clean Water” or “Cat 1 and 2 “, saturations can and should be dried and dried faster from the INSIDE OUT!! ALL saturated cabinets, exterior walls and backside of island counters should be dried from the inside out quickly to prevent. Speed and Drying inside first will give you CONFIDENCE that you have minimized the possibility of fungus! You can dry up to 50 linear feet of walls with one air mover (SAVES ON AMPS) or you may attach an air mover to each unit. You place one of the jets in a pre-punched 1 and 3/8″ hole(AS SHOWN) and swivl the jet in the direction you want your air to flow. (See: Octi-Punch)
Octi-Mat® Floor Drying System: We designed the Octi-Dry® Mat to be “Economical, Versatile, Practical, and Non Complicated. The Octi-Dry® comes with its own duct and sets up in 5 minutes. Attach’s to any Dehumidifier in similar way as lay-flat ducting! The Octi-Mat® allows the “Warm Dry Air” to seep out the bottom layer and break up the “Boundary Layer” of moist air that sits just on top of the “real tongue and groove”, hardwood floor.
Octi-Hole Punch: This tool is ,000.00(just kidding!) or you can make this punch yourself, this is just to get you started!? A lot of Tech’s are still using a drill and bit to access walls. Take a 1″ (inside hole diameter) section of schedule 40 pvc plumbing pipe 16″ long. Cut one end at approximately 60 degree angle. After you have removed the Base Trim, Place the angled end under the caulking line at the desired first location and tap lightly until the tube cuts an access hole to insert the jet of the Octi-Dry® Wall Dryer. Use the 16 inch punch to measure from this hole to the desired location of the next hole!!! This technique came from my long time friend Carl!!! Everyone thanks you Carl!!